Component: lte
1,291 changelog entries across 312 version(s)
Releases by channel (stacked)
- fixed missing automatic redial when cellular connectivity is lost for R11e-LTE;
- fixed framed route support for the first APN;
- fixed missing automatic redial when cellular connectivity is lost for R11e-LTE;
- fixed user set MTU not applied to LTE interface;
- override the "auto" or 0 MTU in "interface" menu to 1500;
- fixed AT modem dialer command timeout (introduced in v7.23beta5);
- fixed operator setting for QMI modems;
- delete CID profiles one by one instead of "delete all" for QMI modems, as command does not work for all modems;
- improved system stability when modem configured in passthrough mode with VLANs for "Chateau 5G R16" and "Chateau 5G";
- keep MAC persistent across reboots for QMI modems;
- added fast SIM switchover support using AT channel for MBIM modems without MBIM_CID_MS_UICC_RESET firmware support;
- configure IP address for AT modems even if no DNS is received from the network;
- do not reconfigure modem in passthrough mode if passthrough cannot be activated because of slave interface;
- fixed automatic modeswitch for "Chateau 5G R16" and "Chateau 5G";
- fixed broken network scan after being interrupted by reconfiguration;
- fixed LTE modem automatic modeswitch (introduced in v7.22);
- fixed missing automatic redial when cellular connectivity is lost for R11e-LTE;
- improved system stability;
- stop network scan on interruption for QMI modems;
- unify "modem-init" for all driver types;
- do not duplicate primary-band also in ca-band for QMI modems in 5G SA network;
- emit RS every 60s on LTE interface;
- filter packets by MAC in multi-apn setup for EC200A-EU modem;
- fixed RSSI signal monitor 3rd party modems where AT+CSQ responses are not parsed;
- fixed Tx stat reporting in LTE passthrough mode (introduced in v7.22);
- fixed user set MTU not applied to LTE interface;
- improved system stability for devices with QMI modems;
- improvements for passthrough mode in IPv6 only setup;
- read subscriber number also for QMI modems;
- removed LTE external-antenna scan;
- set SMS send timeout to 180s;
- show external-antenna as "none" before actual scan is done instead of empty value;
- show MTU as "auto" also on interface level if "auto" used;
- SIMCom modems, skip error state when modem sends improperly formatted CREG response/URC;
- added "auto" MTU option for LTE interfaces to use network-advertised MTU on supported devices;
- added AT command timeout for EC25-EU&KNe;
- added multi-apn and framed routing support for EC200A-EU modem (requires latest FW version);
- added roaming barring field to LTE "show-capabilities" menu;
- added subscriber number to monitor command for MBIM modems;
- added USB tethering support using iOS devices;
- clear about field status on firmware upgrade;
- do not allow modem firmware-upgrade on "inactive" interface;
- do not allow setting unsupported roaming barring settings for R11e-4G;
- do not flap LTE passthrough assigned interface on modem link state change;
- do not reconfigure LTE interface on configuration change error;
- enable DHCP relay packet forwarding to the cellular network for EG120K-EA and RG650E-AU;
- fixed "allow-roaming" setting to return error for modems that do not support roaming barring;
- fixed cases where AT dialer could get stuck in "modem not ready" state;
- fixed cases where incorrect network modes and bands could be suggested for active interface;
- fixed chained firmware update for Chateau 5G;
- fixed changing eSIM profile nickname;
- fixed changing MAC address for EC200A-EU modem;
- fixed crash on LTE passthrough interface deactivation;
- fixed displaying operator name for Chateau ax R17;
- fixed eSIM errors appearing on devices without eSIM support;
- fixed firmware update and status refresh for R11eL-EC200A-EU modem;
- fixed LTE interface IPv6 address generation to use EUI-64 for EC25-EU&KNe;
- fixed missing notifications to eSIM provider when eSIM provisioning canceled;
- fixed tethering support for Google Pixel Pro 8;
- fixed wrong MTU reading/setting for config-less modems;
- hide external antenna selection menu for the Chateau AX R17;
- improved APN IP type handling by enabling only the IP protocols defined in the assigned APN profile for config-less modems;
- make inactive LTE interface settable, LTE interface settings can be set without waiting for modem initial initialization;
- removed delay before querying modem status for config-less modems with info channel;
- show ICCID and IMSI also when the interface is disabled;
- strip modem reported padding characters for SIM card (ICCID) on Chateau ax R17;
- added subscriber number to monitor command for MBIM modems (additional fixes);
- fixed crash on LTE passthrough interface deactivation;
- fixed firmware upgrade for EC25-EU&KNe (introduced in v7.22rc1);
- fixed eSIM profile switching on ATL 5G R16;
- improved notification handling during firmware update for Quectel modems;
- fixed issue for Chateau 5G R17 ax (introduced in v7.21.1);
- added roaming barring field to LTE "show-capabilities" menu (additional fixes);
- added subscriber number to monitor command for MBIM modems;
- do not allow setting unsupported roaming barring settings for R11e-4G;
- fixed chained firmware update for Chateau 5G;
- fixed changing eSIM profile nickname;
- fixed displaying operator name for Chateau ax R17;
- fixed inappropriate external antenna selection on Chateau ax R17;
- fixed missing notifications to eSIM provider when eSIM provisioning canceled;
- fixed tethering support for Google Pixel Pro 8;
- fixed wrong MTU reading/setting for config-less modems;
- added roaming barring field to LTE "show-capabilities" menu;
- fixed "allow-roaming" setting to return error for modems that do not support roaming barring;
- fixed cases where AT dialer could get stuck in "modem not ready" state;
- fixed cases where incorrect network modes and bands could be suggested for active interface;
- fixed modem recovery after unexpected modem reboot for Chateau 5G and Chateau 5G R16 (introduced in v7.22beta1);
- strip modem reported padding characters for SIM card (ICCID) on Chateau ax R17;
- fixed APN configuration for QMI modems in a 3G network when use-network-apn=yes is used;
- added AT command timeout for EC25-EU&KNe;
- do not allow modem firmware-upgrade on "inactive" interface;
- do not reconfigure on AT command timeout for MBIM modems;
- enable DHCP relay packet forwarding to the cellular network for EG120K-EA and RG650E-AU;
- fixed APN configuration for QMI modems in a 3G network when use-network-apn=yes is used;
- fixed roaming barring support for the EC200A-EU modem (introduced in v7.22beta1);
- hide external antenna selection menu for the Chateau AX R17;
- improved APN IP type handling by enabling only the IP protocols defined in the assigned APN profile for config-less modems;
- show ICCID and IMSI also when the interface is disabled;
- added support for R11e-LTE6 v039 firmware release;
- added "force-delete" command to allow deletion of active eSIM profiles;
- added additional logging for error reported by modem during APN profile setup;
- added command to send out EUICC generated notifications manually;
- added confirmation prompt when deleting eSIM profile;
- added support for additional D-Link DWM-222 variation (vendor-id="0x2001" device-id="0x7e46");
- added support for additional Huawei E3372-325 variation (vendor-id="0x3566" device-id="0x2001");
- added support for R11e-LTE6 v039 firmware release and availability notification;
- ask for user confirmation before installing eSIM profile;
- clear SIM not present error when performing modem FW upgrade;
- discontinued support for RBSXTLTE3-7, further versions will use v7.20 LTE firmware package;
- do not retry activation for IPv4 and IPv6 APNs on QMI modems if only one address family is assigned;
- fixed cases where LTE monitor could show abnormalities;
- fixed LTE interface IPv6 address generation to use EUI-64 (introduced in v7.20);
- fixed MTU inheritance from master interface in multi-APN setups;
- fixed MTU setting for AT modems;
- fixed no re-connection after cellular network requested APN deactivation on Chateau 5G ax R17;
- force sms-protocol to AT for FG621-EA modem;
- improved AT modems at-chat control channel handling after modem has closed AT channel unexpectedly;
- improved modem recovery for Chateau 5G and Chateau 5G R16;
- improved stability for FG621-EA modem;
- improved system stability when receiving SMS messages;
- provide firmware download URL when no LTE package installed on "SXT LTE3-7";
- relay EUICC generated notifications after profile enable/disable/remove/provision;
- rework multiapn support for AT modems;
- unify "SIM not present" status for all modems;
- fixed LTE interface IPv6 address generation to use EUI-64 (introduced in v7.20);
- fixed no re-connection after cellular network requested APN deactivation on Chateau 5G ax R17;
- added "auto" MTU option for LTE interfaces to use network-advertised MTU on supported devices;
- added multi-apn and framed routing support for EC200A-EU modem (requires latest FW version);
- added USB tethering support using iOS devices;
- clear about field status on firmware upgrade;
- do not flap LTE passthrough assigned interface on modem link state change;
- do not reconfigure LTE interface on configuration change error;
- fixed changing MAC address for EC200A-EU modem;
- fixed eSIM errors appearing on devices without eSIM support;
- fixed firmware update and status refresh for R11eL-EC200A-EU modem;
- fixed LTE interface IPv6 address generation to use EUI-64 for EC25-EU&KNe;
- improved APN IP type handling by enabling only the IP protocols defined in the assigned APN profile for config-less modems;
- make inactive LTE interface settable, LTE interface settings can be set without waiting for modem initial initialization;
- removed delay before querying modem status for config-less modems with info channel;
- fixed LTE interface IPv6 address generation to use EUI-64 (introduced in v7.20);
- fixed missing IP assignment on non-passthrough LTE interface in multi-apn setup (introduced in v7.21beta2);
- fixed no re-connection after cellular network requested APN deactivation on Chateau 5G ax R17;
- ask for user confirmation before installing eSIM profile (additional fixes);
- ask for user confirmation before installing eSIM profile (CLI and WinBox 4 only) (additional fixes);
- provide firmware download URL when no LTE package installed on "SXT LTE3-7";
- ask for user confirmation before installing eSIM profile (CLI and WinBox 4 only) (additional fixes);
- do not retry activation for IPv4 and IPv6 APNs on QMI modems if only one address family is assigned;
- fixed MTU setting for AT modems;