Search changelog entries
6.43rc6
Testing
2018-May-02 (8 years ago)
| Component |
Change |
|
bridge
|
fixed LLDP packet receiving; |
|
bridge
|
fixed processing of fragmented packets when hardware offloading is enabled; |
|
dhcpv6-relay
|
fixed missing configuration after reboot; |
|
hotspot
|
fixed user authentication when queue from old session is not removed yet; |
|
quickset
|
fixed dual radio mode detection process; |
|
wireless
|
fixed usage of allowed signal strength values received from RADIUS; |
|
wireless
|
improved Nv2 PtMP performance; |
6.43rc5
Testing
2018-Apr-25 (8 years ago)
| Component |
Change |
|
ipsec
|
fixed policies becoming invalid if added after a disabled policy; |
|
led
|
added "dark-mode" functionality for hAP ac and hAP ac^2 devices; |
|
lte
|
allow to execute concurrent internal AT commands; |
|
lte
|
improved r11e-LTE and r11e-LTE-US dialling process; |
|
lte
|
improved reading of SMS message after entering running state; |
|
ssh
|
disconnect all active connections when router gets rebooted or turned off; |
|
tr069-client:
|
fixed setting of "DeviceInfo.ProvisioningCode" parameter; |
|
wireless
|
fixed packet processing when "static-algo-0=40bit-wep" is being used (introduced in v6.42); |
|
wireless
|
improved wireless throughput on hAP ac^2 and cAP ac; |
6.43rc4
Testing
2018-Apr-23 (8 years ago)
| Component |
Change |
|
bridge
|
added ingress filtering options to bridge interface (CLI only); |
|
bridge
|
fixed dynamic VLAN table entries when using ingress filtering; |
|
crs317
|
fixed link flapping when inserted S+RJ10 module without any cable; |
|
ipsec
|
added "responder" parameter for "mode-config" to allow multiple initiator configurations (CLI only); |
|
ipsec
|
added "src-address-list" parameter for "mode-config" that generates dynamic "src-nat" rule (CLI only); |
|
ipsec
|
install all DNS server addresses provided by "mode-config" server; |
|
winbox
|
fixed "/ip dhcp-server network set dns-none" parameter; |
|
winbox
|
show "Switch" menu on hAP ac^2 devices; |
|
winbox
|
show HT MCS tab when "5ghz-n/ac" band is used; |
6.42.1
Stable
2018-Apr-23 (8 years ago)
| Component |
Change |
|
bridge
|
fixed hardware offloading for MMIPS and PPC devices; |
|
bridge
|
fixed LLDP packet receiving; |
|
crs3xx
|
fixed failing connections through bonding in bridge; |
|
ike2
|
use "policy-template-group" parameter when picking proposal as initiator; |
|
led
|
added "dark-mode" functionality for hAP ac and hAP ac^2 devices; |
|
led
|
improved w60g alignment trigger; |
|
lte
|
allow to send "at-chat" command over disabled LTE interface; |
|
routerboard
|
fixed "mode-button" support on hAP lite r2 devices; |
|
w60g
|
allow to manually set "tx-sector" value; |
|
w60g
|
fixed incorrect RSSI readings; |
|
w60g
|
show phy rate on "/interface w60g monitor" (CLI only); |
|
winbox
|
fixed bridge port MAC learning parameter values; |
|
winbox
|
show "Switch" menu on cAP ac devices; |
|
winbox
|
show correct "Switch" menus on CRS328-24P-4S+; |
|
wireless
|
improved compatibility with BCM chipset devices; |
6.40.8
Long-term
2018-Apr-23 (8 years ago)
| Component |
Change |
|
certificate
|
fixed incorrect SCEP URL after an upgrade; |
|
health
|
fixed empty measurements on CRS328-24P-4S+RM; |
|
ike2
|
use "policy-template-group" parameter when picking proposal as initiator; |
|
ipv6
|
fixed IPv6 behaviour when bridge port leaves bridge; |
|
routerboard
|
fixed "mode-button" support on hAP lite r2 devices; |
|
ssh
|
fixed SSH service becoming unavailable; |
|
traffic-flow
|
fixed IPv6 destination address value when IPFIX protocol is used; |
|
winbox
|
show "Switch" menu on cAP ac devices; |
|
wireless
|
improved compatibility with BCM chipset devices; |