MikroTik RouterOS changelogs
| Component | Change |
|---|---|
| bgp | moved "interface bgp-vpls" menu to "routing bgp vpls"; |
| bgp | remove unused commands and parameters; |
| bluetooth | improved long-term service stability; |
| bridge | fixed TCP, UDP port parsing for loop detect warning; |
| capsman | fixed bridge disabling when using L2 connection; |
| ccr | improved interface link stability on CCR2004-16G-2S+PC; |
| chr | fixed Cloud DDNS update after license renewal; |
| console | fixed "terminal inkey" command; |
| crs1xx/2xx | improved system stability during switch reset; |
| defconf | do not add passthrough ports to local bridge on CCR2004-1G-2XS-PCIe; |
| ipv6 | fixed dynamic non link-local addresses displaying; |
| l2tp | added VRF support for L2TP client; |
| l3hw | greatly improved route offloading speed; |
| l3hw | log HW routes count and the shortest offloaded subnet prefix if the HW memory gets full; |
| l3hw | offload only main routing table; |
| l3hw | partial routing table offload for Marvell Prestera DX4000/DX8000 switch chip series; |
| lhgg | improved system stability (introduced in v7.2); |
| lte | improved LTE interface initialization process on LtAP-2HnD; |
| mpls | made LDP bindings work on PPP interfaces; |
| ospf | ignore instance route when originate-default=if-installed is enabled; |
| ovpn | fixed server instance not responding to incoming connections after reboot on CHR; |
| profile | added "wireguard" process classificator; |
| profile | added "zerotier" process classificator; |
| qsfp | reset module only when all ports are disabled; |
| queue | allow to set higher limits than 4G; |
| queue | display warning for CAKE type in simple and tree setups when "bandwidth" parameter is configured; |
| resource | fixed CPU type display under system resources for ARM and ARM64; |
| routerboot | prevent enabling "protected-routerboot" on unsupported factory firmware versions; |
| smb | fixed SMB2 file list reporting; |
| snmp | added VRF support; |
| ssh | fixed private key usage after downgrade; |
| winbox | added "Default Cost" parameter under "Routing/OSPF/Area" menu; |
| winbox | fixed "Type" values under "IP/Route" menu; |
| winbox | fixed minor typo in reboot confirmation prompt; |
| winbox | made wireless access list entries sortable when using the wifiwave2 package; |
| ww2 | general stability and throughput improvements; |
| x86 | added support for Solarflare SFC1920 NIC; |
| x86 | fixed soft-id reading on virtualized x86 installations (introduced in v7.2); |
| Component | Change |
|---|---|
| bgp | added "name" parameter for connections; |
| bgp | fixed "keepalive-timeout" value when upgrading from RouterOS v6; |
| bgp | fixed "l2vpn" distribution; |
| bridge | added more details for loop detection warning; |
| bridge | do not set VLAN on inactive port with a "set" command; |
| bridge | ignore VLAN tagged BPDU; |
| capsman | improved traffic processing over CAP communication tunnels: |
| chr | fixed Cloud DDNS update after license renewal; |
| dot1x | fixed RADIUS State attribute when client is reauthenticated; |
| dot1x | fixed port based VLAN ID assignment on devices without a switch chip; |
| dot1x | improved server system stability during authentication; |
| ipsec | fixed printing of active peer statistics; |
| l3hw | improved offloading in cases of HW table overflow for CRS305, CRS326-24G-2S+, CRS328, CRS318, CRS310; |
| l3hw | optimized offloading when dealing with large volume of directly connected hosts; |
| lte | added SMS sending support for MBIM protocol; |
| lte | allow only MCC/NMC format in "operator" parameter; |
| lte | clear SIM values when modem in "stopped" state; |
| mpls | improved LDP AF selection process and behavior; |
| ntp | do not allow setting port number in "server" parameter; |
| ovpn | adjusted SHA2 authentication algorithm naming to allow legacy OpenVPN implementations to connect; |
| ovpn | improved server stability under continous overload; |
| ovpn | reply with the same IP address that the connection was established to; |
| ppp | added support for VRF; |
| romon | fixed VLAN tagged packet processing; |
| route | fixed IPv6 /127 route nexthop resolution; |
| routerboot | prevent enabling "protected-routerboot" on unsupported factory firmware versions; |
| sfp | fixed link flap for QSFP+ and QSFP28 ports connected with a breakout cable, in cases where the base interface changes "running" state (introduced in v7.3beta33); |
| sfp | hide empty monitor values in console; |
| snmp | added VRF support (CLI only); |
| snmp | fixed reported disk size when multiple external disks are attached; |
| snmp | report "ifSpeed" as 0 if value out of bounds (use "ifHighSpeed" for high speed interfaces instead); |
| ssh | added AES-GCM cipher support; |
| ssh | removed DSA public key authentication support; |
| supout | added simplified IPv4 and IPv6 routing table prints; |
| switch | fixed "switch-cpu" port stats for 98DXxxxx and 98PX1012 switches (introduced in v7.3beta37); |
| switch | fixed missing stats in traffic-monitor for 98DXxxxx and 98PX1012 switches; |
| system | fixed Kernel timer consistency; |
| tunnels | improved packet handling over EoIP, IPIP and GRE tunnels; |
| vpls | fixed TE transport path usage after startup; |
| vrrp | fixed learning of bridged local MAC addreses; |
| winbox | added missing "IBGP", "EBGP", "Limit Exceeded" and "Stopped" parameters under "Routing/BGP/Sessions" menu; |
| winbox | added missing "Keep Sent Attributes" parameter under "Routing/BGP/Connection" menu; |
| winbox | added missing "Scan List" parameter for W60G interfaces; |
| winbox | added missing BGP session commands; |
| winbox | added support for 2.5Gbps and 100Gbps Ethernet speed options; |
| winbox | do not show "Session Uptime" parameter under "LTE" menu if not supported by modem; |
| winbox | fixed "Disconnect Timeout" parameter type under "CAPsMAN" menu; |
| winbox | fixed "IP/Cloud" window refreshing after changes are detected; |
| winbox | properly load band values under "LTE" menu; |
| winbox | removed obsolete "Routing Table" parameter under "IP/Firewall" menu; |
| Component | Change |
|---|---|
| bgp | added initial support for prefix limit; |
| bgp | improved stability when editing BGP template; |
| bonding | fixed LACP flapping for RB5009 and CCR2004-16G-2S+ devices; |
| ccr | added visible "passthrough" flag for interfaces on CCR2004-1G-2XS-PCIe; |
| ccr | usability and stability improvements for passthrough interfaces on CCR2004-1G-2XS-PCIe; |
| cd-install | allow selecting on which drive to install RouterOS; |
| conntrack | limited full Connection Tracking warning to 1 message per minute; |
| crs3xx | fixed storm rate on 1Gbps interfaces for CRS354 devices; |
| defconf | suggest user to set up new password; |
| dhcpv4-server | fixed minor logging typo; |
| fetch | improved full disk detection; |
| filesystem | fixed possible boot failure on RB850Gx2 and RB1100AHx2; |
| filesystem | improved long-term filesystem stability and data integrity; |
| gps | fixed minor value unit typo; |
| ipv6 | removed bogus commands from IPv6 neighbors menu; |
| l3hw | improved offloading for directly connected hosts on CRS305, CRS326-24G-2S+, CRS328, CRS318, CRS310; |
| l3hw | improved route table offloading for CRS317, CRS309, CRS312, CRS326-24S+2Q+, CRS354, CRS5xx, CCR2x16 devices; |
| leds | fixed ethernet LED behavior on wAP R ac; |
| leds | fixed wireless related LED behavior with WW2 package; |
| lte | added SMS sending support for MBIM protocol; |
| lte | added support for generic PXA1802 based modems; |
| lte | disabled wait for LTE auto attach; |
| lte | hide slave interfaces from export; |
| lte | improved stability when upgrading LTE firmware on Chateau 5G; |
| mlag | fixed MAC address moving between bridge ports; |
| mpls | do MPLS forwarding for nexthops without mappings; |
| mpls | fixed MPLS MTU and path MTU selection; |
| mpls | fixed MPLS forwarding after any interface configuration parameter is changed; |
| ospf | fixed GRE interface compatibility with OSPF; |
| ospf | improved stability when enabling or removing interface-template entries; |
| ovpn | fixed memory leak on TILE architecture; |
| ovpn | fixed packet processing on MT7621A; |
| ovpn | improved Windows client disconnect procedure in UDP mode; |
| ovpn | improved service stability when processing frequent disconnects in UDP mode; |
| ovpn | improved stability when forwarding traffic on TILE; |
| ping | fixed socket allocation after VRF change; |
| ppp | fixed "remote-ipv6-prefix" parameter unsetting; |
| ppp | fixed active sessions sometimes getting stuck; |
| ppp | fixed issue with multiple active sessions when "only-one" is enabled; |
| queues | improved stability in large list of queue scenarios; |
| rb5009 | fixed 10G linking issues with Intel X520, XXV710 NICs; |
| route | fixed "table" menu emptying after RouterOS upgrade; |
| route | fixed static routes in VRF becoming invalid after reboot; |
| route-filter | fixed community matchers; |
| rsvp-te | improved stability when "Resv" received for non-existing session; |
| supout | added RIP section; |
| system | fixed IP service initialization in VRF after system startup; |
| system | fixed rare partial loss of RouterOS configuration after package upgrade/downgrade/install/uninstall; |
| torch | properly capture all related IPv6 traffic; |
| upnp | improved stability when processing incomplete HTTP header; |
| vpls | fixed "pw-l2mtu" parameter usage; |
| vrf | fixed VRF leaking; |
| winbox | do not show "unknown" area under "Routing/OSPF/LSA" menu; |
| winbox | do not show type value for NXDOMAIN entries under "IP/DNS/Cache" menu; |
| winbox | made "Interface Templates" table sortable under "Routing/OSPF" menu; |
| winbox | properly clean up SFP module information after it is unplugged; |
| winbox | properly clean up disk after a failed file upload; |
| winbox | show PVID column by default under "Bridge" menu; |
| wireless | fixed EAP-TLS authentication; |
| wireless | fixed GUD version in 3gpp information; |
| ww2 | fixed VLAN tag handling; |
| x86 | improved support for i40e driver; |
| x86 | improved support for Intel E810 NIC; |
| Component | Change |
|---|---|
| bonding | fixed LACP flapping for RB5009 and CCR2004-16G-2S+ devices; |
| bridge | fixed packet marking for IP/IPv6 firewall; |
| dot1x | improved server stability when using re-authentication; |
| fetch | improved full disk detection; |
| gps | fixed minor value unit typo; |
| l3hw | improved offloading for directly connected hosts on CRS305, CRS326-24G-2S+, CRS328, CRS318, CRS310; |
| led | fixed QSFP+, QSFP28 activity LEDs when using 40Gbps modules (introduced in v7.3beta33); |
| lte | disabled wait for LTE auto attach; |
| mpls | fixed MPLS MTU and path MTU selection; |
| ovpn | fixed hardware offloading support on CHR; |
| ovpn | improved Windows client disconnect procedure in UDP mode; |
| ovpn | moved authentication failure messages to "info" logging level; |
| ppp | added warning when using prefix length other than /64 for router advertisement; |
| ppp | fixed "remote-ipv6-prefix" parameter unsetting; |
| ppp | fixed issue with multiple active sessions when "only-one" is enabled; |
| routerboot | properly reset system configuration when protected bootloader is enabled and reset button used; |
| rsvp-te | improved stability when "Resv" received for non-existing session; |
| sfp | improved QSFP/SFP interface initialization for 98DXxxxx switches; |
| switch | fixed missing stats from traffic-monitor for 98DXxxxx and 98PX1012 switches; |
| system | fixed RouterOS bootup when wifiwave2 package is installed (introduced in v7.3beta34); |
| system | fixed rare partial loss of RouterOS configuration after package upgrade/downgrade/install/uninstall; |
| user-manager | improved stability when received EAP attribute with non-existing state attribute; |
| vpls | fixed "pw-l2mtu" parameter usage; |