Version: 7.3beta40
Testing50 changelog entries across 25 component(s)
2022-May-11 (3 years ago)
| Component | Change |
|---|---|
| bgp | added "name" parameter for connections; |
| bgp | fixed "keepalive-timeout" value when upgrading from RouterOS v6; |
| bgp | fixed "l2vpn" distribution; |
| bridge | added more details for loop detection warning; |
| bridge | do not set VLAN on inactive port with a "set" command; |
| bridge | ignore VLAN tagged BPDU; |
| capsman | improved traffic processing over CAP communication tunnels: |
| chr | fixed Cloud DDNS update after license renewal; |
| dot1x | fixed RADIUS State attribute when client is reauthenticated; |
| dot1x | fixed port based VLAN ID assignment on devices without a switch chip; |
| dot1x | improved server system stability during authentication; |
| ipsec | fixed printing of active peer statistics; |
| l3hw | improved offloading in cases of HW table overflow for CRS305, CRS326-24G-2S+, CRS328, CRS318, CRS310; |
| l3hw | optimized offloading when dealing with large volume of directly connected hosts; |
| lte | added SMS sending support for MBIM protocol; |
| lte | allow only MCC/NMC format in "operator" parameter; |
| lte | clear SIM values when modem in "stopped" state; |
| mpls | improved LDP AF selection process and behavior; |
| ntp | do not allow setting port number in "server" parameter; |
| ovpn | adjusted SHA2 authentication algorithm naming to allow legacy OpenVPN implementations to connect; |
| ovpn | improved server stability under continous overload; |
| ovpn | reply with the same IP address that the connection was established to; |
| ppp | added support for VRF; |
| romon | fixed VLAN tagged packet processing; |
| route | fixed IPv6 /127 route nexthop resolution; |
| routerboot | prevent enabling "protected-routerboot" on unsupported factory firmware versions; |
| sfp | fixed link flap for QSFP+ and QSFP28 ports connected with a breakout cable, in cases where the base interface changes "running" state (introduced in v7.3beta33); |
| sfp | hide empty monitor values in console; |
| snmp | added VRF support (CLI only); |
| snmp | fixed reported disk size when multiple external disks are attached; |
| snmp | report "ifSpeed" as 0 if value out of bounds (use "ifHighSpeed" for high speed interfaces instead); |
| ssh | added AES-GCM cipher support; |
| ssh | removed DSA public key authentication support; |
| supout | added simplified IPv4 and IPv6 routing table prints; |
| switch | fixed "switch-cpu" port stats for 98DXxxxx and 98PX1012 switches (introduced in v7.3beta37); |
| switch | fixed missing stats in traffic-monitor for 98DXxxxx and 98PX1012 switches; |
| system | fixed Kernel timer consistency; |
| tunnels | improved packet handling over EoIP, IPIP and GRE tunnels; |
| vpls | fixed TE transport path usage after startup; |
| vrrp | fixed learning of bridged local MAC addreses; |
| winbox | added missing "IBGP", "EBGP", "Limit Exceeded" and "Stopped" parameters under "Routing/BGP/Sessions" menu; |
| winbox | added missing "Keep Sent Attributes" parameter under "Routing/BGP/Connection" menu; |
| winbox | added missing "Scan List" parameter for W60G interfaces; |
| winbox | added missing BGP session commands; |
| winbox | added support for 2.5Gbps and 100Gbps Ethernet speed options; |
| winbox | do not show "Session Uptime" parameter under "LTE" menu if not supported by modem; |
| winbox | fixed "Disconnect Timeout" parameter type under "CAPsMAN" menu; |
| winbox | fixed "IP/Cloud" window refreshing after changes are detected; |
| winbox | properly load band values under "LTE" menu; |
| winbox | removed obsolete "Routing Table" parameter under "IP/Firewall" menu; |