MikroTik Changelogs
← Back to search All versions

Version: 7.2rc5

Testing

72 changelog entries across 37 component(s)

2022-Mar-23 (4 years ago)

Component Change
api accept "Content-Type" with specified charset;
arm fixed "auto" CPU frequency setting;
arm64 improved Watchdog initiated reboot reason reporting;
backup fixed cloud backup's creation timezone;
bgp added BGP advertisements display (requires output.keep-sent-attributes to be set);
bgp fixed link-local iBGP address selection;
bgp fixed network advertisement from address-lists after reboot;
bridge fixed firewall "ingress-priority" matcher and "new-priority=from-ingress" action settings from VLAN tagged frames;
ccr2004 improved system stability on CCR2004-12S+2XS;
crs1xx/2xx fixed static switch host addresses after link down;
crs1xx/2xx ignore static bridge host addresses (switch unicast-fdb should be used instead);
dhcpv6 added VRF support;
dude fixed The Dude client compatibility with RouterOS v7;
firewall improved available port lookup for source NAT when free port range is exhausted;
ipsec fixed "identities" menu emptying after RouterOS upgrade/reboot;
ipv6 do not add duplicate dynamic prefix when static already exists;
ipv6 fixed "retransmissit-interval" unit value;
ipv6 fixed VLAN tagged PPPoE packet receiving on RB5009;
l2tp fixed CHAP challenge packet processing over IPsec;
l3hw improved routing table offloading for CRS305, CRS326-24G-2S+, CRS328, netPower, netFiber devices;
led fixed LED behavior on Audience;
led reduced LTE signal LED range to -70;
log added warning message when connection tracking table is full;
lte add IPv6 address on interface as well;
lte added support for Uplink CA reporting;
lte changed "CS/PS" registration type from "both" to "any" on R11e-LTE un R11e-LTE6;
lte do not loose "band" configuration after reboot on Chateau 5G;
lte fixed AT command response handling on R11e-LTE;
lte fixed MBIM modem reset on AT timeout;
lte fixed link flapping when loosing cellular signal on R11e-LTE un R11e-LTE6;
ntp improved service stability when none of the NTP servers are reachable for a while;
ospf general stability improvements;
ospf improved DB retransmit logging;
ospf send notifies for neighbors;
ovpn improved memory allocation on Tile in "ethernet" mode;
ovpn improved system stability in high load scenarios;
pimsm fixed menu prints;
pimsm general stability improvements;
queue fixed queued IPv6 traffic considered as "invalid" by Firewall;
rb4011 fixed jumbo frame processing on SFP+ port when using 1G module;
rip added logging;
rip fixed route metrics;
rip fixed route redistribution;
rip use nexthop with interface;
route fixed "table" menu emptying after RouterOS upgrade;
route fixed BGP atomic aggregate value;
route fixed ECMP route removal;
route general stability improvements;
routerboard fixed "ether2" interface presence on some RBwAPGR devices;
routerboard fixed WPS button functionality on Audience;
routing added PCAP viewer tool for BGP advertisements debugging purposes;
routing-filter fixed "bgp-*-communities-empty" matcher;
sfp improved SFP module detection on CRS106 and CRS112;
smips improved RAM allocation;
switch added "rx-overflow" counter for 88E6393X (RB5009) and 88E6191X (CCR2004-16G-2S+) switch chips;
switch improved packet forwarding with enabled "cpu-flow-control" setting between different rate interfaces for 88E6393X (RB5009) and 88E6191X (CCR2004-16G-2S+) switch chips;
tr069-client added support for 5G band configuration;
tr069-client added support for wireless "skip-DFS" configuration;
winbox added missing "3GGP RAW" parameter under "Interface/Wireless/Interworking Profile" menu;
winbox added missing "accounting", "interim-update" and "radius-password" parameters under "IP/DHCP Server" menu;
winbox allow adding more than 100 tagged/untagged interfaces under "Bridge/VLAN" menu;
winbox allow configuring "VTEP" under "Interface/VXLAN" menu;
winbox fixed "00:00:00" time printing;
winbox fixed switch related settings for MT7621 switch chip (hEX, hEX S, RBM33G, RBM11G, LtAP);
winbox moved IPv4 and IPv6 "Rules" menus under "Routing" menu;
winbox properly show "v" flag instead of "y" under "IP/Route" menu;
winbox properly update server list under "System/NTP Client/Servers" menu;
winbox show "System/Health/Settings" only on boards that have configurable values;
www fixed "tls-version" for SSL;
x86 allow to select disk for install image;
x86 fixed NVME partition path;
zerotier fixed IPv6 support;