Version: 6.43rc51
Testing50 changelog entries across 25 component(s)
2018-Aug-01 (7 years ago)
| Component | Change |
|---|---|
| bridge | added per-port based "tag-stacking" feature; |
| bridge | fixed "ingress-filtering", "frame-types" and "tag-stacking" value storing; |
| bridge | improved bridge port state changing process; |
| bridge | improved packet processing when bridge port changes states; |
| bridge | renamed option "vlan-protocol" to "ether-type"; |
| certificate | do not allow to perform "undo" on certificate changes; |
| crs3xx | added command that forces fan detection on fan-equipped devices; |
| crs3xx | fixed port disable on CRS326 and CRS328 devices; |
| dhcpv6-client | allow to set "default-route-distance"; |
| dhcpv6-client | fixed "add-default-route" parameter; |
| dhcpv6-client | fixed option handling; |
| dhcpv6-server | added additional RADIUS parameters for Prefix delegation, "rate-limit" and "life-time"; |
| ethernet | fixed default ethernet advertise values after configuration reset (introduced in v6.43rc33) |
| filesystem | fixed NAND memory going into read-only mode (requires "factory-firmware" >= 3.41.1 and "current-firmware" >= 6.43); |
| health | fixed voltage measurements for RB493G devices; |
| hotspot | allow to properly configure Hotspot directory on external disk for devices that have flash type storage; |
| hotspot | fixed RADIUS CoA & PoD by allowing to accept "NAS-Port-Id"; |
| ike1 | added unsafe configuration warning for main mode with pre-shared-key authentication; |
| ike1 | zero out reserved bytes in NAT-OA payload; |
| ike2 | fixed rekeyed child deletion during another exchange; |
| ike2 | improved basic exchange logging readability; |
| ipsec | fixed "sa-src-address" deduction from "src-address" in tunnel mode; |
| ipsec | fixed "static-dns" value storing (CLI only); |
| ipsec | fixed AES-CTR and AES-GCM key size proposing as initiator; |
| ldp | properly load LDP configuration; |
| led | fixed default LED configuration for RBLHGG-5acD-XL devices; |
| lte | added "registration-status" parameter under "/interface lte info" command; |
| lte | added additional D-Link PIDs; |
| lte | added additional low endpoint SIM7600 PIDs; |
| lte | added signal readings under "/interface lte scan" for 3G and GSM modes; |
| lte | fixed memory leak on USB disconnect; |
| lte | fixed SMS send feature when not in LTE network; |
| lte | ignore empty MAC addresses during Passthrough discovery phase; |
| lte | properly detect interface state when running for IPv6 only connection for R11e-LTE modem; |
| multicast | allow to add more than one RP per IP address for PIM; |
| ospf | improved link-local LSA flooding; |
| rb1100ahx4 | added DES and 3DES hardware acceleration support; |
| routerboot | removed RAM test from TILE devices (routerboot upgrade required); |
| sfp | hide "sfp-wavelength" parameter for RJ45 transceivers; |
| snmp | added "phy-rate" reading for "station-bridge" mode; |
| snmp | fixed "remote-cap" peer MAC address format; |
| ssh | strengthen strong-crypto (add aes-128-ctr and disallow hmac sha1 and groups with sha1); |
| tile | added DES and 3DES hardware acceleration support; |
| w60g | added distance measurement feature; |
| w60g | fixed random disconnects; |
| w60g | improved MCS rate detection process; |
| w60g | improved MTU change handling; |
| w60g | properly close connection with station on disconnect; |
| wireless | fixed "/interface wireless sniffer packet print follow" output; |
| wireless | fixed packet processing after removing wireless interface from CAP settings; |