MikroTik Changelogs

Search changelog entries

6.43rc11 Testing 2018-May-10 (8 years ago)
Component Change
bridge do not allow to add same interface list to bridge more than once;
console fixed type "on" and "wireless-status" LED trigger value setting (introduced in v6.43rc1);
dhcpv4-server do not allow override lease "always-broadcast" value based on offer type;
dhcpv4-server improved performance when "rate-limit" and/or "address-list" setting is present;
dhcpv6-server added initial dynamic simple queue support;
filesystem fixed situation when filesystem goes into read-only mode on device with NAND type memory;
filesystem improved software crash handling on devices with FLASH type memory;
interface fixed "built-in=no" parameter for manually created interface lists;
interface fixed "dynamic" built-in interface list behavior;
interface fixed interface list which include/exclude another list;
interface fixed interface list which include disabled member;
interface fixed situation when router did reboot due to critical program crash (introduced in v6.42);
interface improved reliability on dynamic interface handling;
lte added extended signal information for Quectel LTE EP06 modem;
lte improved LTE communication process on MMIPS platform devices;
routerboard properly represent board name for hAP ac^2;
switch added support for port isolation by switch chip (CLI only);
tile fixed Ethernet interfaces becoming unresponsive;
wireless do not disconnect clients when WDS master connects with MAC address "00:00:00:00:00:00";
6.43rc7 Testing 2018-May-08 (8 years ago)
Component Change
capsman allow to change "radio-name" (CLI only);
dhcpv4 prevent sending out ICMP port unreachable packets;
dhvpv4-client fixed DHCP client stuck in renewing state;
kidcontrol allow to edit discovered devices;
lte do not allow to send "at-chat" commands for configless modems;
6.43rc6 Testing 2018-May-02 (8 years ago)
Component Change
bridge fixed LLDP packet receiving;
bridge fixed processing of fragmented packets when hardware offloading is enabled;
dhcpv6-relay fixed missing configuration after reboot;
hotspot fixed user authentication when queue from old session is not removed yet;
quickset fixed dual radio mode detection process;
wireless fixed usage of allowed signal strength values received from RADIUS;
wireless improved Nv2 PtMP performance;
6.43rc5 Testing 2018-Apr-25 (8 years ago)
Component Change
ipsec fixed policies becoming invalid if added after a disabled policy;
led added "dark-mode" functionality for hAP ac and hAP ac^2 devices;
lte allow to execute concurrent internal AT commands;
lte improved r11e-LTE and r11e-LTE-US dialling process;
lte improved reading of SMS message after entering running state;
ssh disconnect all active connections when router gets rebooted or turned off;
tr069-client: fixed setting of "DeviceInfo.ProvisioningCode" parameter;
wireless fixed packet processing when "static-algo-0=40bit-wep" is being used (introduced in v6.42);
wireless improved wireless throughput on hAP ac^2 and cAP ac;
6.43rc4 Testing 2018-Apr-23 (8 years ago)
Component Change
bridge added ingress filtering options to bridge interface (CLI only);
bridge fixed dynamic VLAN table entries when using ingress filtering;
crs317 fixed link flapping when inserted S+RJ10 module without any cable;
ipsec added "responder" parameter for "mode-config" to allow multiple initiator configurations (CLI only);
ipsec added "src-address-list" parameter for "mode-config" that generates dynamic "src-nat" rule (CLI only);
ipsec install all DNS server addresses provided by "mode-config" server;
winbox fixed "/ip dhcp-server network set dns-none" parameter;
winbox show "Switch" menu on hAP ac^2 devices;
winbox show HT MCS tab when "5ghz-n/ac" band is used;