Search changelog entries
| Component | Change |
|---|---|
| certificate | fixed "add-scep" template existence check when signing certificate; |
| defconf | fixed wAP LTE kit default configuration; |
| ethernet | improved large packet handling on ARM devices with wireless; |
| ethernet | removed obsolete slave flag from "/interface vlan" menu; |
| filesystem | fixed NAND memory going into read-only mode; |
| hotspot | fixed user authentication when queue from old session is not removed yet; |
| interface | fixed interface configuration responsiveness; |
| ipsec | fixed policies becoming invalid if added after a disabled policy; |
| ldp | properly load LDP configuration; |
| ppp | fixed "hunged up" grammar to "hung up" within PPP log messages; |
| sfp | hide "sfp-wavelength" parameter for RJ45 transceivers; |
| snmp | added remote CAP count OID for CAPsMAN; |
| supout | added "partitions" section to supout file; |
| tile | fixed Ethernet interfaces becoming unresponsive; |
| tr069-client | fixed unresponsive tr069 service when blackhole route is present; |
| userman | fixed compatibility with PayPal TLS 1.2; |
| userman | improved unique username generation process when adding batch of users; |
| winbox | added missing "dscp" and "clamp-tcp-mss" settings to IPv6 tunnels; |
| winbox | allow to specify full URL in SCEP certificate signing process; |
| winbox | by default specify keepalive timeout value for tunnel type interfaces; |
| winbox | show firmware upgrade message at the bottom of "System/RouterBOARD" menu; |
| winbox | show "scep-url" for certificates; |
| winbox | show "sector-writes" on ARM devices that have such counters; |
| winbox | show "sector-writes" on devices that have such counters; |
| winbox | show "System/Health" only on boards that have health monitoring; |
| wireless | added option to disable PMKID for WPA2; |
| wireless | enable all chains by default on devices without external antennas after configuration reset; |
| wireless | fixed packet processing after removing wireless interface from CAP settings; |
| wireless | improved client "channel-width" detection; |
| wireless | improved Nv2 PtMP performance; |
| wireless | increased stability on hAP ac^2 and cAP ac with legacy data rates; |
| wireless | updated "united-states" regulatory domain information; |
| Component | Change |
|---|---|
| bridge | improved bridge port state changing process; |
| crs326/crs328 | fixed untagged packet forwarding through tagged ports when pvid=1; |
| crs3xx | added command that forces fan detection on fan-equipped devices; |
| crs3xx | fixed port disable on CRS326 and CRS328 devices; |
| crs3xx | fixed tagged packet forwarding without VLAN filtering (introduced in 6.42.6); |
| crs3xx | fixed VLAN filtering when there is no tagged interface specified; |
| dhcpv4-relay | fixed false invalid flag presence; |
| dhcpv6 | improved reliability on IPv6 DHCP services; |
| dhcpv6-client | allow to set "default-route-distance"; |
| dhcpv6-server | properly update interface for dynamic DHCPv6 servers; |
| ethernet | improved large packet handling on ARM devices with wireless; |
| ethernet | removed obsolete slave flag from "/interface vlan" menu; |
| ipsec | fixed "sa-src-address" deduction from "src-address" in tunnel mode; |
| ipsec | improved invalid policy handling when a valid policy is uninstalled; |
| ldp | properly load LDP configuration; |
| led | fixed default LED configuration for RBLHGG-5acD-XL devices; |
| lte | added signal readings under "/interface lte scan" for 3G and GSM modes; |
| lte | fixed memory leak on USB disconnect; |
| lte | fixed SMS send feature when not in LTE network; |
| package | do not allow to install out of bundle package if it already exists within bundle; |
| ppp | fixed interface enabling after a while if none of them where active; |
| sfp | hide "sfp-wavelength" parameter for RJ45 transceivers; |
| tr069-client | fixed unresponsive tr069 service when blackhole route is present; |
| upgrade | fixed RouterOS upgrade process from RouterOS v5; |
| userman | fixed compatibility with PayPal TLS 1.2; |
| vrrp | fixed VRRP packet processing on VirtualBox and VMWare hypervisors; |
| w60g | added distance measurement feature; |
| w60g | fixed random disconnects; |
| w60g | general stability and performance improvements; |
| w60g | improved MCS rate detection process; |
| w60g | improved MTU change handling; |
| w60g | properly close connection with station on disconnect; |
| w60g | stop doing distance measurements after first successful measurement; |
| winbox | added "secondary-channel" setting to wireless interface if 80 MHz mode is selected; |
| winbox | fixed "sfp-connector-type" value presence under "Interface/Ethernet"; |
| winbox | fixed warning presence for "IP/IPsec/Peers" menu; |
| winbox | properly display all flags for bridge host entries; |
| winbox | show "System/RouterBOARD/Mode Button" on devices that has such feature; |
| wireless | added option to disable PMKID for WPA2; |
| wireless | fixed memory leak when performing wireless scan on ARM; |
| wireless | fixed packet processing after removing wireless interface from CAP settings; |
| wireless | updated "united-states" regulatory domain information; |
| Component | Change |
|---|---|
| bridge | added support for BPDU Guard (CLI only); |
| bridge | added support for DHCP Option 82 (disables hardware offloading, CLI only); |
| bridge | added support for DHCP Snooping (disables hardware offloading, CLI only); |
| bridge | forward LACPDUs when "protocol-mode=none"; |
| bridge | improved packet handling; |
| cloud | added simultaneous IPv4/IPv6 support; |
| console | added "dont-require-permissions" parameter for scripts; |
| dhcpv4-relay | fixed false invalid flag presence; |
| dhcpv6-server | do not allow to run DHCPv6 server on slave interface; |
| dhcpv6-server | fixed dynamic simple queue creation for RADIUS bindings; |
| dhcpv6-server | properly update interface for dynamic DHCPv6 servers; |
| ethernet | fixed possible link flaps after disabling/enabling the interface (introduced in v6.43rc51); |
| ethernet | improved large packet handling on ARM devices with wireless; |
| ethernet | removed obsolete slave flag from "/interface vlan" menu; |
| hotspot | fixed customized HTML file usage (introduced in 6.43rc47); |
| ike1 | zero out reserved bytes in NAT-OA payload; |
| ike2 | fixed initiator first policy selection; |
| ippool | improved used address error message; |
| ipsec | added warning messages for incorrect peer configuration; |
| ipsec | separate phase1 proposal configuration from peer menu; |
| ppp | fixed interface enabling after a while if none of them where active; |
| ppp | improved modem mode switching; |
| snmp | added "temp-exception" trap; |
| switch | fixed possible switch chip hangs after initialization on MediaTek and Atheros8327 switch chips; |
| tile | fixed false HW offloading flag for MPLS; |
| tr069-client | allow editing of "provisioning-code" attribute (CLI only); |
| tr069-client | fixed unresponsive tr069 service when blackhole route is present; |
| upgrade | fixed RouterOS upgrade process from RouterOS v5; |
| ups | improved UPS serial parsing stability; |
| w60g | general stability and performance improvements; |
| w60g | stop doing distance measurements after first successful measurement; |
| winbox | added "default-route-distance" parameter for "IPv6/DHCP-client" menu; |
| winbox | fixed "sfp-connector-type" value presence under "Interface/Ethernet"; |
| winbox | fixed warning presence for "IP/IPsec/Peers" menu; |
| winbox | fixed "write-sect-since-reboot" value presence under "System/Resources"; |
| winbox | show "System/RouterBOARD/Mode Button" on devices that has such feature; |
| wireless | added option to disable PMKID for WPA2 (CLI only); |
| wireless | fixed memory leak when performing wireless scan on ARM; |
| wireless | updated "united-states" regulatory domain information; |
| Component | Change |
|---|---|
| bridge | added per-port based "tag-stacking" feature; |
| bridge | fixed "ingress-filtering", "frame-types" and "tag-stacking" value storing; |
| bridge | improved bridge port state changing process; |
| bridge | improved packet processing when bridge port changes states; |
| bridge | renamed option "vlan-protocol" to "ether-type"; |
| certificate | do not allow to perform "undo" on certificate changes; |
| crs3xx | added command that forces fan detection on fan-equipped devices; |
| crs3xx | fixed port disable on CRS326 and CRS328 devices; |
| dhcpv6-client | allow to set "default-route-distance"; |
| dhcpv6-client | fixed "add-default-route" parameter; |
| dhcpv6-client | fixed option handling; |
| dhcpv6-server | added additional RADIUS parameters for Prefix delegation, "rate-limit" and "life-time"; |
| ethernet | fixed default ethernet advertise values after configuration reset (introduced in v6.43rc33) |
| filesystem | fixed NAND memory going into read-only mode (requires "factory-firmware" >= 3.41.1 and "current-firmware" >= 6.43); |
| health | fixed voltage measurements for RB493G devices; |
| hotspot | allow to properly configure Hotspot directory on external disk for devices that have flash type storage; |
| hotspot | fixed RADIUS CoA & PoD by allowing to accept "NAS-Port-Id"; |
| ike1 | added unsafe configuration warning for main mode with pre-shared-key authentication; |
| ike1 | zero out reserved bytes in NAT-OA payload; |
| ike2 | fixed rekeyed child deletion during another exchange; |
| ike2 | improved basic exchange logging readability; |
| ipsec | fixed "sa-src-address" deduction from "src-address" in tunnel mode; |
| ipsec | fixed "static-dns" value storing (CLI only); |
| ipsec | fixed AES-CTR and AES-GCM key size proposing as initiator; |
| ldp | properly load LDP configuration; |
| led | fixed default LED configuration for RBLHGG-5acD-XL devices; |
| lte | added "registration-status" parameter under "/interface lte info" command; |
| lte | added additional D-Link PIDs; |
| lte | added additional low endpoint SIM7600 PIDs; |
| lte | added signal readings under "/interface lte scan" for 3G and GSM modes; |
| lte | fixed memory leak on USB disconnect; |
| lte | fixed SMS send feature when not in LTE network; |
| lte | ignore empty MAC addresses during Passthrough discovery phase; |
| lte | properly detect interface state when running for IPv6 only connection for R11e-LTE modem; |
| multicast | allow to add more than one RP per IP address for PIM; |
| ospf | improved link-local LSA flooding; |
| rb1100ahx4 | added DES and 3DES hardware acceleration support; |
| routerboot | removed RAM test from TILE devices (routerboot upgrade required); |
| sfp | hide "sfp-wavelength" parameter for RJ45 transceivers; |
| snmp | added "phy-rate" reading for "station-bridge" mode; |
| snmp | fixed "remote-cap" peer MAC address format; |
| ssh | strengthen strong-crypto (add aes-128-ctr and disallow hmac sha1 and groups with sha1); |
| tile | added DES and 3DES hardware acceleration support; |
| w60g | added distance measurement feature; |
| w60g | fixed random disconnects; |
| w60g | improved MCS rate detection process; |
| w60g | improved MTU change handling; |
| w60g | properly close connection with station on disconnect; |
| wireless | fixed "/interface wireless sniffer packet print follow" output; |
| wireless | fixed packet processing after removing wireless interface from CAP settings; |
| Component | Change |
|---|---|
| ethernet | improved stability when changing ethernet interface L2MTU on CRS328-24P-4S+ (introduced in v6.43rc11); |
| ipsec | improved invalid policy handling when a valid policy is uninstalled; |
| lte | added additional ID support for SIM7600 modem; |
| sfp | fixed default advertised link speeds; |
| vrrp | fixed VRRP packet processing on VirtualBox and VMWare hypervisors; |
| winbox | properly display all flags for bridge host entries; |
| winbox | show "System/RouterBOARD/Mode Button" on devices that has such feature; |
| wireless | improved Nv2 reliability on ARM devices; |