Version: 7.10beta8
Testing54 changelog entries across 24 component(s)
2023-May-22 (2 years ago)
| Component | Change |
|---|---|
| bgp | allow to filter BGP sessions by AFI; |
| bgp | changed default VPNv4 import distance to iBGP value (200); |
| bgp | do not check route distinguisher on import; |
| bgp | fixed "as-override" and rename to "output.as-override"; |
| bgp | fixed "remove-private-as" and rename to "output.remove-private.as"; |
| bgp | show address family in advertisements; |
| bgp | show approximate received prefix count by the session; |
| branding | fixed custom logo (introduced in v7.8); |
| conntrack | added read-only "active-ipv4" and "active-ipv6" fields to "/ip/firewall/connection/tracking" (CLI only); |
| console | fixed "print without-paging" output in some cases; |
| defconf | allow to use device factory preset credentials in Flashfig and Netinstall configuration files; |
| dhcpv4-server | added name for "IPv6-Only Preferred" option (108) in debug logs; |
| doh | less verbose logging; |
| ipsec | added hardware acceleration support for IPQ-5010 (hAP ax lite); |
| ipsec | removed "ec2n185" and "ec2n155" values from proposal configurations; |
| l3hw | added "autorestart" option to L3HW settings; |
| l3hw | added error message and reset "l3-hw-offloading=no" if L3HW driver fails to start; |
| l3hw | fixed offloading of /32 IPv4 and /128 IPv6 routes; |
| l3hw | improved offloading of IPv6 hosts after L3HW driver restart; |
| l3hw | improved performance of partial offloading; |
| l3hw | improved route offloading after gateway change; |
| lora | improved gateway card detection and upgrade logic; |
| lora | updated firmware version for LoRaWAN gateway (for R11e-LoRa8, R11e-LoRa9 cards); |
| lte | fixed APN authentication for R11e-LTE6 modem; |
| lte | improved MBIM modem firmware reported error handling when settings RAT modes; |
| lte | improved modem firmware upgrade stability for MBIM modems; |
| lte | reduced SIM slot switchover time for MBIM modems with UUIC reset support; |
| netwatch | added warning about non-running probe due to "startup-delay" (CLI only); |
| poe | fixed bogous "poe-in-voltage" values when using DC jack for RB5009; |
| qos-hw | renamed VLAN "priority" field to "pcp" to avoid confusion; |
| rose-storage | added support for multiple smb users and smb shares; |
| routerboot | increased "preboot-etherboot" maximum value to 30 seconds ("/system routerboard upgrade" required); |
| scheduler | fixed incorrectly started scheduler during reboot or shutdown; |
| sfp | fixed combo-sfp linking at 1G rate for CRS312 switch; |
| sfp | improved module compatibility with bad EEPROM data for RB4011, RB5009, CCR2xxx, CRS312 and CRS518 devices; |
| sniffer | fixed large .pcap file limit; |
| snmp | added BGP peer table support IPv4 only (1.3.6.1.2.1.15.3.1); |
| tr069 | added 5G SCC "SNR" parameter for modems that report it; |
| vrrp | added warning if "sync-connection-tracking=yes" while the global connection tracking is inactive; |
| vrrp | added warning if the VRRP group is misconfigured; |
| vrrp | added warning if VRRP or its interface does not have an IP address; |
| vrrp | do not start connection synchronization if the global connection tracking is inactive; |
| vrrp | fixed issue where disabled VRRP interface is affecting group; |
| vrrp | fixed VRRP interface state on physical cable disconnection; |
| vrrp | improved system stability on changing "group-authority" or "sync-connection-tracking"; |
| vrrp | renamed "group-master" to "group-authority" to avoid confusion with VRRP master; |
| vrrp | send VRRP announcements only by "group-authority"; |
| wifiwave2 | do not include in radio hardware capability list a parameter irrelevant to end users (introduced in 7.10beta5); |
| wifiwave2 | fixed CAP interface name when using "name-format"; |
| wifiwave2 | fixed connectivity issues wheen access-list is used; |
| wifiwave2 | fixed wireless throughput issues after 802.11r client roaming events on 802.11ac devices; |
| wifiwave2 | improve protections against DoS attacks on WPA3-PSK; |
| wifiwave2 | less verbose logging when WPA3-PSK clients are connecting; |
| wireguard | retry "endpoint-address" DNS query on failed resolve; |