Version: 6.7
Stable19 changelog entries across 11 component(s)
2013-Nov-29 (12 years ago)
| Component | Change |
|---|---|
| address-list | allow manually adding timeoutable entries; |
| address-list | show dynamic entry timeout; |
| certificate | support ip, dns and email subject alternative names; |
| dhcpv4 server | added REMOTE_ID option variable for relayed packets; |
| fixed l2mtu changing on CCRs | could cause port flapping; |
| fixed port flapping on CCR | could happen when having other than only-hardware-queue interface queue. Note that having other interface queue than only-hardware-queue dramatically reduces performace, so should be avoided if possible; |
| general | support Android usb tethering interface; |
| general | fixed hairpin nat on bridge with use-ip-firewall=yes; |
| general | fixed vlan on bridge after reboot having 00:00:00:00:00:00 mac address; |
| general | disabling/enabling ethernet ports did not work properly on CCRs, could cause port flapping; |
| ipsec | added aes-gcm icv16 encryption mode; |
| ipsec | added aes-ctr encryption mode; |
| ipsec | added sha256 and sha512 support; |
| ipsec | proposal defaults changed to aes-128 and sha1 for both phase1 and phase2; |
| ipsec | fix policy bypass on IPv6 gre, ipip, eoip tunnels when policy uses protocol filter; |
| leds | inverted modem signal trigger, now it will trigger when the signal level rises above the treshold; |
| poe | new poe controller firmware for RB750UP and OmniTIK UPA; |
| userman | fix crash on tilera; |
| wireless | improve rate selection for nstreme protocol |